AMP L 8000-840 PC MB LDO

This data set has been modeled according to the European Standard EN 15804+A2 for Sustainable Building. Results are depicted in modules that allow the structured expression of results over the entire life cycle. Transport modul: A Standard scenario with a truck with a transport distance of 700 km in Europe is considered. The weight of the transported unit includes product with packaging. Use-stage modul: During the use-stage, consumption of electricity is calculated, based on a for the declared product characteristical, standardardised scenario. All use-scenarios are defined in the [PCR part B] of IBU. Not only annual operating time, average product lifetime and power consumption is considered but also additional influences like stand-by circuits, dimming function and more. The following electricity grid mix is applied by default: EU Allocation of waste material: For the treatment of production residues the calculation considers the increased demand of materials' input resulting in production residues during manufacturing. These material flows are not connected to an EoL-scenario. Avoided burdens for secondary material in case of potential recycling are not included. End-of-life modul: As an EoL scenario the product as well as the replacement parts are assumed to be collected to 100% (legal requirements defined within WEEE directive). The product and replacement parts are fed to a generic shredding process with fixed demand on electrical energy per input mass (C3) of 1,2 MJ/kg, resulting in different waste fractions. For the amount of metal flows respective recycling processes are considered, including recycling losses. Environmental burdens of recycling processes, as well as avoided burdens for secondary materials are assigned as total value in module D. The plastic fraction is fed into a process for waste incineration (B4/C3). The calculation of emissions from the waste incineration plant follows a partial stream consideration for the combustion process, according to an average mix of plastics.

LED Moisture-proof diffuser luminaire with IP66 protection rating and drip-edge effect for minimising dirt and collection of dust for maximum hygienic requirements. Luminaire input power: 53.8 W, Slave luminaire for DALI control (DALI only) with LED converter; patented InvisiClick for clipless mounting and opening of the cover. Cover and basic diffuser made of impact-resistant polycarbonate, temperature- and UV-resistant, made as a single injection-moulded piece. LED service life lasts 100000 h before luminous flux is reduced to 90% of the initial value. Chromaticity tolerance (initial MacAdam): 3. Luminaire luminous flux: 8130 lm, Luminaire efficacy: 151 lm/W. Colour rendering Ra > 80, colour temperature 4000 K. Luminaire with symmetric distribution (medium beam). Mounting via V2A standard spring clips to ceilings, walls or trunking. 5-pole connector terminal. Suitable for through-wiring with H05VV or NYM cable (10A). ambient temperature: -25°C to +32°C. Approved for indoor use with vertical or horizontal wall mounting (see installation instructions). Note: please contact your consultant if you are planning to use the luminaire in environments with chemical pollutants, high or condensing humidity and major variations in temperature. Complies with International Food Standard specifications. Designed for BESA box. Permissible for use in environments where the deposition of conductive dust on the luminaire can be expected (EN 60598-2-24). Protection class: SC1, 850 °C glow-wire tested. Luminaire wired with halogen-free leads, silicone-free, Impact strength: IK08, Dimensions: 1600 x 92 x 90 mm; weight: 3 kg. The manufacturing process includes production technologies such as plastic injection moulding, plastics processing, metalworking and powder coating, as well as the operation of highly automated systems for assembling the products. All primary and secondary data are modelled to be specific to the technologies or technology mixes under study. Where technology-specific data are unavailable, proxy data are used. Technological representativeness is considered to be good.

The declared product is a professional LED luminaire that is used for application 'Manufactur'.