Door - Hörmann Legnica - side door NT3

This data set contains the results for modules A1-A3 and modules A4, A5, B2, B3, B5, B6, B7, C1, C2, C3, C4, D. The production of packaging was taken into account within modules A1-A3

The life cycle assessment results cover the life cycle stages from the manufacture of primary products to the extraction of raw materials and processing of secondary materials used as input (e.g. recycling processes), their transportation to the plant and the production itself, including the provision of all auxiliary and operating materials, energy, as well as the complete waste treatment or landfilling of residual waste during the production stage. Modules A1, A2 and A3 are shown here as an aggregated module A1-A3. If further modules were calculated for this data set, these can be found separately and can be combined for a consideration of the entire life cycle.

Side door (NT 3) for ET 500 Non-protruding up-and-over garage doors and ST 500 sliding garage doors (see EPD-SGT-0.11.1). Door elements 1-leaf, appearance as collective garage doors with steel or aluminium infill. Frame for single-leaf door element made of galvanised square tube (84 × 60 mm), powder-coated in door leaf colour. Visible width 84.2 mm. Surface protection: the galvanised frame profiles are powder-coated in white aluminium in accordance with RAL 9006 as standard. Colour, preferred colours based on RAL colour chart. Fittings and lock: Side door as standard with handle, PZ version, black plastic, lock without profile cylinder (required profile cylinder length 40.5 / 40.5 mm, plus panel thickness for motif 405), concealed hinges. The clear passage width is reduced when the opening angle is less than 180°. The side doors are not driveable. Motifs 420, 422 and 480 are equipped with a lowerable floor seal as standard.